PCL workshop pro air hose reel

A hose reel keeps the floor clear, protects the hose and saves you tripping over it. Here is what to look at before you buy one.

1. Retractable or manual

Spring-retract reels pull the hose back in when you release it, which is handy for a busy workshop. Manual reels are simpler and usually cheaper, and suit places where the hose is pulled out once and left.

2. Hose length and bore

Pick the length you actually need, then check the bore. A longer hose with a small bore loses pressure, so see our guide on what size air hose you need. Our reels are listed with their hose length and internal diameter, for example the PCL Workshop Pro reel with 15m of 10mm ID hose or the 20m PCL Workshop Pro reel, so you can compare like for like. For a smaller job, the ABAC automatic hose reel has 10m of PVC hose on a 180 degree swivel.

3. Pressure rating

Check the reel and hose are rated above your compressor's maximum pressure.

4. Mounting

Most reels mount on a wall or ceiling bracket. Pick a spot close to where you work, near your air line outlet, with room to pull the hose out in a straight line.

5. The connection to your air line

The inlet needs a fitting that matches your pipework, usually a BSP thread. If you are unsure, read our BSPP vs BSPT guide.

Common questions

Can I leave the hose under pressure?

It is good practice to isolate the air supply when the reel is not in use, which also helps you spot leaks. See our leaks guide.

Where can I see them?

Browse our hose reels or call us on 021 435 5424.